| FGD-0013 Water Sensor |
 |
Water Detection Sensor
Can be used with all Sensaphone ®
models to detect the presence of water on a horizontal
surface. Independently powered by internal lithium batteries.
Multiple sensors can be wired in series to a single input.
Dimensions: 2.25" x 1.125" x 3.625 |
| |
|
| FGD-0027 Humidistat |
 |
Humidistat
Can be used with all Sensaphone ®
models to detect too high or too low a humidity level.
Range of the humidistat is 10% to 60% RH. The sensor causes
an alarm when the humidity exceeds or falls below the set
limit. Multiple sensors may be wired to a single input.
Dimensions: 4.125" x 2.75" x 1.5"
|
| |
|
| FGD-0006 Magnetic
Reed Switch |
 |
Magnetic Reed Switch
May be used with all Sensaphone ®
models to detect any unauthorized entry or intrusion.
Usually installed on doors and windows, the sensors monitor
their opening and closing. Several magnetic reed switches
may be wired in series.
Dimensions:2.5" x 0.75" x 0.5" (part with screw
terminals)2.5" x 0.75" x 0.625" (part with
magnet) |
| |
|
| FGD-0100 Remote Temperature
Sensor |
 |
Remote Temperature Sensor
Enables you to monitor temperature at a location away from
your Sensaphone unit. Measures and tells you the exact temperature
and triggers an alarm when conditions exceed the set high/low
limits. May be mounted anywhere air temperature needs to be
measured and can be used with all Sensaphone ® models.
Ranges: For models 1104 & 1108: -29oC
to 65oC (-20oF
to 150oF)
For Express, Express II, ISACC & Sensaphone 2000: -51oC
to 80oC (-60oF
to 175oF)
Only one sensor may be wired per input.
Dimensions: 2.5" x .75" x .75" |
| |
|
| FGD-0007 Passive Infra-Red
Motion Detector |
 |
Passive Infra-Red Motion Detector
Can be used with all Sensaphone ®
models to monitor the movement of warm bodies in a specific
area. Will cause a dialout if motion is detected. Range of
detection covers approximately 50 ft. of area. Multiple sensors
can be wired in series to a single input.
Dimensions: 4" x 6" x 1.5" |
| |
|
| FGD-0015 AC Output Module / FGD-0016 DC Output
Module / FGD-0017 DC Input Module / FGD-0018 AC Input
Module |
 |
Modular I/O System
System consists of 4 solid state relays (modules) and a 4-module
rack for use with the Sensaphone ISACC The AC and DC solid
state output relays are wired to the output terminals to control
loads such as fans, horns, valves and motors. The AC and DC
solid state input relays are wired to alert inputs to monitor
the presence or absence of AC or DC voltage, respectively.
The rack accepts up to 4 relays for installation.
4-Module Rack
Accepts up to 4 solid state input/output modules
Dimensions: 3.5" x 4.5" x 1.5"
Dimensions for each module: 1.75" x 1" x 0.375" |
| |
|
| FGD-0010 Accessory
Hook-Up Wire |
 |
Accessory Hook-Up Wire
50 ft. of 22-gauge wire used to connect a sensor away from
a Sensaphone unit. Appropriate for wiring all the sensors
available in this catalog, and for most monitoring applications.
|
